- 30.03.2017
- Posted by: admin
- Category:
Regulators of humidity and temperature

Regulator humidity sensor and temperature;
Sensor built-in or connected to an external probe;
Two relay outputs or SSR, adjusting ON-OFF type with hysteresis;
Output analog or digital (optional)
Temperature compensation in the measurement of moisture;
Dual LED screen with the keyboard;
Protection IR65.
DOWNLOAD – Regulators of humidity and temperature
Converters humidity and temperature

Yield analog or digital;
Temperature compensation of the measured humidity;
Long-term measurement stability;
Calculation of Dew Point / rime (° C), the absolute humidity (g / m)
LED LCD screen with a keyboard (optional)
Setting via the interface or control panel;
Protection IR65.
DOWNLOAD – Converters humidity and temperature
converters universal
Linear transformation of the measured temperature into a current signal;
Universal thermometric input Pt100, J, K, S, E, N;
Current output 4 – 20 mA (2-wire powered in loop) or naprugovy 0 – 10 (3-wire)
No galvanic separation of the input / output;
Alarm LED excess conversion range or sensor error;
Mounting on bus DIN, the degree of protection IR20.
DOWNLOAD – converters universal
Distributors

The separator serves for galvanic isolation loop;
The separator is a passive, requires no power;
Mounting on TS35 bus.
DOWNLOAD – Distributors
Process controls
Universal thermometric and analog input;
Two measuring range of the indicator and the set point;
Programmable input type, the display range and other parameters; Type of control: ON-OFF with hysteresis, RAMPPING, PID, self-tuning PID;
2 relay outputs or SSR (solid state relay);
RS485 interface, MODBUS-RTU (optional)
Analog Outputs: 0/4 – 20 mA, or 0 – 10V (optional)
Display panel 48 x 48 mm, IR65.
DOWNLOAD – AR-600
DOWNLOAD – AR-630, AR-640, AR-650, AR-660, AR-680, AR-602, AR-625, AR-642, AR-652, AR-682, AR-632
Universal thermometric and analog input;
Programmable input type, the display range and other parameters.;
Type of control: ON-OFF with hysteresis, AUTOTUNING PID, PID;
2 relay outputs or SSR;
Interface RS232C or RS485, MODBUS-RTU (optional)
Analog Outputs: 0/4 – 20 mA, or 0 – 10 (optional)
Display panel 115 x 45 x 55 mm, IR65.
DOWNLOAD – AR-601 and AR-651
Universal thermometric input signal;
Programmable input and in.parametriv type;
Type of control: ON-OFF with hysteresis, PID;
1 relay or SSR (solid state relay);
Display panel: AR601 dimensions 48 x 48 mm, IR65 protection;
AR651 dimensions 96 x 48 mm, IR65 protection;
Ramp-voltage meter signals

Universal output (via external fixators)
current (active) …………. 0 / 4-20mA,
voltage …………. 0-10V;
Power from the batteries (3 x 1.2V NiMH AA type)
LED display (7 segment and bargraphs) red with control of brightness;
Programmable step output signal changes;
A programmable display range;
Displays the real output values listed regarding display range;
Displays the status of battery charging;
Auto device at low battery charge;
Function cutoff device when not in use for a certain period;
Access to the configuration parameters is protected by a password, programming keyboard, the degree of protection IR54;
DOWNLOAD – Ramp-voltage meter signals
Calibrator

Input / output (programmable) ……… Pt100 (standard), Ni100 (2-wire and 3), J, K, S, B, R, T, E, N (compensation temperature cold ends) -5 – 55mV, 10 – 540 ohms, 0 – 3.2 ohms;
Accuracy ……… Pt100, -5 – 55mV, 10 – 540 ohms <0.2% range of the sensor, Ni100, thermocouples <0.2% range of the sensor ± 1 digit;
The error task ……… Pt100, Ni100 <0,2s for Il> 200mA, J, K, E, N 55mV 0 – 3.2 ohms <0.2% range <1.5% ohm 0 – 3.2 ohms, S, B, R, T <0,3% range;
drag input current (RTD, Ohm) 100-1900 mA (simulation)
Step tasks in the simulation 0,5-200S (programmable)
(Batteries or accumulators) 2 x 1,5 V (2 x 1,2 V NiMH)
Hours 300-400 Hours for batteries 2 x 1,5 V / 2500mAh;
Working conditions 0-50S, 0-90% RH (non-condensing).
DOWNLOAD – Calibrator AR-915
Wireless Recorder

ar406 Radio Mnogookanal’nij temp, humidity and standard signals, 4 alarms, 128 x 64 graphics display, USB, SD card, Ethernet, 96 x 96.
Wireless sensors

Wireless sensor is designed to transmit measurements from the onboard temperature sensor AR406 recorder or PC
AR431-single-channel sensor without LCD
AR432-LCD with a single-channel sensor
AR433-input dual-purpose sensor without LCD
AR435-universal input dual LCD with sensor
AR436-humidity and temperature sensor without dual LCD
